Class d car amplifier review:X2000

Issuing time:2020-01-04 00:18

Car Amplifier Mono Block 2000W Review

ØModel number: X2000

ØFeatures:

2000W rms Class-D amplifier.

1 ohm load stable.

Double Side PCB and SMD components.

Adjustable Input level, LPF, Subsonic, bass boost function, Q control.

Advanced short circuit, overload, over heat protection.

Advanced clip limit / thermal power limit function.

Easy bridgeable with same amplifier.

Optional remote controller.

ØDetailed specs:

1.
Test Condition.ì

All the specs were tested with following condition unless noted.

1
Power supply: 14.4V DC power supply

2
Test signal: 80Hz sine wave.

3
Loads: Resistor dummy load.

4
Environment: 25 degree C, open air.

5
Relative humidity: 70%.

6
Instrument: Audio Precision SYS-2322A.

1.
Output power performance

Following table is the RMS output power with THD+N(<22KHz) value at 5%, 3%, 2% and 1%.

    Power

THD+N

RMS power (1ohm)

RMS power (2ohm)

RMS power(4ohm)

5%

2000W

1350W

780W

3%

1920W

1300W

760W

2%

1900W

1260W

740W

1%

1800W

1160W

660W

Table
Output Power with THD+N

Following chart shows the output power with THD+N curve at 4ohm loads, 2ohm loads and 1ohm loads.


Chart 1
RMS output power @4ohm with THD+N


Chart 2
RMS output power @2ohm with THD+N


Chart 3
RMS power @1ohm with THD+N

1.
Frequency Response

1. -3dB frequency response: 13Hz~224Hz.

2. -1dB frequency response: 18Hz~175Hz.


1.
LPF & Subsonic Filter features

7
LPF adjustable from 35Hz~224Hz with 24dB/Oct slope.

8
Subsonic Filter adjustable from 14Hz~60Hz with 24dB/Oct slope.


Chart 4
LPF response


Chart 5
Subsonic Filter response

1.
Bass Boost Feature

Bass boost center frequency adjustable from 34Hz~90Hz, level adjustable from

0~13dB.


Chart 6
Bass boost frequency adjust(bass boost level set @ 12dB)



Chart 7
Bass boost level adjust (bass boost frequency set at 48Hz)

1.
Bass boost Q control


Chart 9. Bass boost Q control (bass boost frequency set at 50 Hz)                        

1.
THD+N

THD+N=0.165% @ 375W output power with 4ohm load.

1.
Input level 0.2V~5V

1.
Signal and Noise Ratio >75dB

1.
Protect Function

1.
Overload: Protect less than 0.8 Ohm loads at full scale output power.

2.
Short Circuit: Full rated power short circuit protect test: passed.

Full rated power long last short circuit test: 10 minutes passed.

3.
Over temperature: Limit output power while inner temperature reach 75

degree C, protect while inner temperature reach 85 degree C.

4.
Low voltage: Protect while power supply voltage lower than 8.6V.

5. Over voltage: Protect while power supply voltage over 15.6V.

6. Power limit / Clip limit.Clip limit while THD+N≥1%. Power limit while inner

temperature over 75 degree C.

1.
Idle current and Efficiency:

9 Idle current: 1.39A

10 Efficiency:

Load

4 OHM

2 OHM

1 OHM

Efficiency (THD+N @ 1 % )

89.6%

83.7%

76.0%

1.Bridge method

X2000 can be bridged with same amplifier through single RCA cable, no addition switch

needed. All the adjustable functions on slave amplifier will follow master once be

bridged.

1.
Dimension This amplifier’s size is at 228mmX393mmX53mm(W,L,H).

X2000.1.jpg


Share to:
Address

F2,Building 1 Deng Wu Industry Park, Qiaolong Rd. 582, Qiaotou Tow, Dongguan, Guangdong

Phone +86 186-0300-8861
       (Wechat ID yubaudio)
Email

sales@yubaoaudio.com